TRUNK COMPARTMENT LIGHT
TRUNK COMPARTMENT LIGHT BULB REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the lens, then remove the trunk compartment light bulb.
3. Install in the reverse order of removal.
TRUNK COMPARTMENT LIGHT SWITCH INSPECTION
NOTE:
• The trunk compartment light switch is built into the trunk lock.
1. Remove the trunk lid trim.(See TRUNK LID TRIM REMOVAL/INSTALLATION .)
2. Disconnect the trunk compartment light switch connector.
3. Verify that the continuity between the trunk compartment light switch terminals is as indicated in the
table.
To Next Page
Loading...
