NOISE FILTER
NOISE FILTER REMOVAL/INSTALLATION
Brake Light Noise Filter
1. Disconnect the negative battery cable.
2. Remove the lower panel.(See LOWER PANEL REMOVAL/INSTALLATION .)
3. Peel off the tape.
4. Disconnect the connector and remove the brake light noise filter.
5. Install in the reverse order of removal.
Rear Window Defroster Noise Filter
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Rear seat(See REAR SEAT REMOVAL/INSTALLATION .)
b. Console(See CONSOLE REMOVAL/INSTALLATION .)
c. Tire house trim(See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
d. Rear pillar trim(See REAR PILLAR TRIM REMOVAL/INSTALLATION .)
e. Rear package center trim, rear package side trim(See REAR PACKAGE TRIM
REMOVAL/INSTALLATION .)
3. Remove in the order indicated in the table.
1 Bolt
2 Connector
3 Noise filter
To Next Page
Loading...
