SUPPLIER IDENTIFICATION PROCEDURE
NOTE:
• The supplier can vary with the module.When asking the supplier (service center) for repair or
replacement, identify the supplier and fill in the Audio Repair Order Form using the following
procedures.
Identification Using the Label or Inscribed Lettering
1. Remove the audio unit.
2. Verify the supplier by referring to the label attached to each unit.
Identification Using the On-board Diagnostic Test Mode.
1. Start the on-board diagnostic test mode.
2. Identify the device and supplier codes by referring to the LCD display.
NOTE:
• If no DTC is stored, no codes will be displayed.
Device code Device code
00 Cassette deck
03 CD player
05 CD changer (external)
06 CD changer (upper module)
07 MD player
09 Base unit
To Next Page
Loading...
