Mazda RX8 - Page 331

NO.3 TRANSMITTER ID CODE CANNOT BE REPROGRAMMED
3 Transmitter ID code cannot be reprogrammed
DESCRIPTION
• Malfunction in transmitter battery, transmitter, keyless receive bracket, keyless
receive bracket ground screw, or keyless control module circuit. keyless receive
circuit.
POSSIBLE
CAUSE
• Malfunction in transmitter battery, transmitter, keyless receive bracket, keyless
receive bracket ground screw, or keyless control module, or keyless receive.
Diagnostic procedure
STEP INSPECTION ACTION
Yes Go to the next step.
1
INSPECT TRANSMITTER BATTERY
INSTALLATION AND TYPE
• Visually inspect the transmitter battery.
• Are the below items correct?
 Transmitter battery installation (correct
polarity)
 Battery type (CR2025)
No
Install the transmitter battery
properly or replace with the
specified transmitter battery
(CR2025), then go to Step 13.
Yes
Replace the transmitter battery or
repair the transmitter battery
terminal, then go to Step 13.
2
INSPECT TRANSMITTER BATTERY TERMINALS
FOR RUST AND POOR CONNECTION
• Visually inspect the transmitter.
 Is there rust on the transmitter battery
terminals (positive or negative)?
 Is there poor connection between the terminals
and battery?
No Go to the next step.
Yes Go to the next step.
3
INSPECT TRANSMITTER BATTERY
• Inspect the transmitter battery.
• Is the battery voltage normal?
No
Replace the transmitter battery,
then go to Step 13.
4 Yes Go to the next step.
(w) RX-8 Body
Page 331