Mazda RX8 - Page 340

before beginning the procedure do not
have to be new keys. Any key that is
capable of starting the engine before
beginning the procedure can be used.
Replacing all keys. (When
replacing the steering lock or
similar procedure)
• New keys (two or
more keys)
• WDS or
equivalent
• Since the steering lock is replaced, keys
used before replacement become
unusable. Have two new keys or more
ready before beginning the procedure.
• Unless keys are registered after
replacing the steering lock, the engine
cannot be started.
3
Changing the method for
registering additional keys.
(Method for registering other
keys using two keys that can
start the engine is disabled.)
• WDS or
equivalent
• After performing this procedure it is not
possible to register additional keys
according to procedure No.1.The system
can be returned to the original setting.
The WDS or equivalent must always be
used to change the system setting.
4
Changing the method for
registering additional keys.
(Method for registering other
keys using two keys that can
start the engine is enabled.)
• WDS or
equivalent
• This is the default setting on new
vehicles.
4
Replacing the keyless control
module.
• New keyless
control module
• Keys for
registration (two
or more keys)
• WDS or
equivalent
• Unless keys are re-registered after
replacement, the engine cannot be
started. Before beginning the procedure,
verify that the customer has turned in all
of the keys for the vehicle.
• Unless two or more keys are registered
after replacement, the engine cannot be
started.
• The keys (two or more keys) readied
before beginning the procedure do not
have to be new keys. Any key that is
capable of starting the engine before
beginning the procedure can be used.
5
Replacing the PCM.
• New PCM
• WDS or
- 5
(w) RX-8 Body
Page 340