• After reading out the "Outcode", do not turn ignition switch from LOCK to ON position 5 times,
otherwise the "Outcode" value will be changed.
4. Input the corresponding "Incode" for the "Outcode" displayed on the WDS or equivalent screen.
5. After successfully performing security access, "Program Additional Ignition Key", "Ignition key ID
number Erase" or "Customer Spare Key Programming Enable/Disable" is displayed on the WDS or
equivalent screen. When performing "Parameter Reset", security access is requested two times and after
successfully performing it the second time, "Replacement Module" is displayed.
To Next Page
Loading...
