• Using another valid key, turn the
ignition switch to the ON position.
• Verify the DTC using the WDS or
equivalent.
Is B1600/P1260 displayed
again?
No
• Dispose of the malfunctioning key.
• Register a new key if necessary.
(See IMMOBILIZER SYSTEM
COMPONENT REPLACEMENT/KEY
ADDITION AND CLEARING .)
Yes
Replace the keyless control module and perform
procedures for when replacing the keyless control
module only.
(See KEYLESS CONTROL MODULE
REMOVAL/INSTALLATION .)
(See IMMOBILIZER SYSTEM COMPONENT
REPLACEMENT/KEY ADDITION AND
CLEARING .)
6
INSPECT KEYLESS CONTROL
MODULE
• Using the registered key, turn the
ignition switch to the ON position.
Is B1600/P1260 displayed
again?
No DTC troubleshooting completed.
To Next Page
Loading...
