FUEL-FILLER LID OPENER
FUEL-FILLER LID OPENER REMOVAL/INSTALLATION
1. To remove the fuel-filler lid opener, remove the trunk side trim (LH). (See TRUNK SIDE TRIM
REMOVAL/INSTALLATION .)
2. When removing the fuel-filler lid opener lever, perform the following procedure:
a. Remove the inner scuff plate (driver's side). (See INNER SCUFF PLATE
REMOVAL/INSTALLATION .)
b. Remove the front side trim (driver's side). (See FRONT SIDE TRIM
REMOVAL/INSTALLATION .)
c. Remove the fasteners and the wiring harness clips, and then partially peel back the floor covering
so that the fuel-filler lid opener lever can be removed.
3. When removing the fuel-filler lid opener cable, perform the following procedure:
a. Partially peel back the trunk mat.
b. Remove the rear seat (driver's side). (See REAR SEAT REMOVAL/INSTALLATION )
c. Remove the tire house trim (driver's side). (See TIRE HOUSE TRIM
REMOVAL/INSTALLATION .)
d. Partially peel back the floor covering so that the fuel-filler lid opener cable can be removed.
To Next Page
Loading...
