REAR DRAIN HOSE INSTALLATION
CAUTION:
• If the rear drain hose is pinched or bent at any point, the water in the hose may not drain and could leak
inside the vehicle.During and after installation of the trims and headliner, always make sure there is no
interference with the rear drain hose.Correct any abnormality if found.
1. Apply soapy water to the part of the sunroof frame where the rear drain hose is inserted.
2. Insert the rear drain hose end into the sunroof frame.
3. Install the rear drain hose to the clips parallel to the pillar and free of looseness.
4. Insert the rear drain hose grommet into the hole of the inner rear pillar.
5. Install the following parts:
a. Trunk side trim(See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
b. Trunk end trim(See TRUNK END TRIM REMOVAL/INSTALLATION .)
c. Headliner(See HEADLINER REMOVAL/INSTALLATION .)
d. Assist handle(See ASSIST HANDLE REMOVAL/INSTALLATION .)
e. Sunvisor(See SUNVISOR REMOVAL/INSTALLATION .)
f. Interior light(See INTERIOR LIGHT REMOVAL/INSTALLATION .)
To Next Page
Loading...
