WINDOW GLASS
WINDSHIELD REMOVAL
1. Remove the following parts:
a. Windshield wiper arm and blade(See WINDSHIELD WIPER ARM AND BLADE
REMOVAL/INSTALLATION .)
b. Cowl grille(See COWL GRILLE REMOVAL/INSTALLATION .)
c. Rearview mirror(See REARVIEW MIRROR REMOVAL/INSTALLATION .)
d. A-pillar trim(See A-PILLAR TRIM REMOVAL/INSTALLATION .)
e. Sunvisor(See SUNVISOR REMOVAL/INSTALLATION .)
f. Map light(See MAP LIGHT REMOVAL/INSTALLATION .)
2. Set the headliner out of the way.
3. Apply protective tape along the edge of the body.
4. Apply protective tape to the dashboard to protect it from damage.
5. Cut the windshield molding lip using a razor.
WARNING:
• Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
NOTE:
• The windshield molding is a replacement part.
Not Reusing Windshield
NOTE:
• For the areas of the sealant that are difficult to cut, use the SST (piano wire) and follow the procedure
under "Reusing Windshield".
1. Remove the base.(See BASE REMOVAL .)
2. Cut out the sealant all around the glass using a sealant remover.
To Next Page
Loading...
