Mazda SKYACTIV-G 2.5 - Adjustment; Rubber Parts and Tubing; Torque Formulas

• Depending on location:
— Sealant and gaskets, or both, should be
applied to specified locations. When sealant
is applied, parts should be installed before
sealant hardens to prevent leakage.
— Oil should be applied to the moving
components of parts.
— Specified oil or grease should be applied at
the prescribed locations (such as oil seals)
before reassembly.
Adjustment
• Use suitable gauges and testers when making
adjustments.
Rubber Parts and Tubing
• Prevent gasoline or oil from getting on rubber
parts or tubing.
Torque Formulas
• When using a torque wrench-SST or equivalent
combination, the written torque must be
recalculated due to the extra length that the SST
or equivalent adds to the torque wrench.
Recalculate the torque by using the following
formulas. Choose the formula that applies to you.
A : The length of the SST past the torque wrench drive.
L : The length of the torque wrench.
bpe2ue00000116
bpe2ue00000117
bpe2ue00000118
Torque Unit Formula
N·m N·m × [L/(L+A)]
kgf·m kgf·m × [L/(L+A)]
kgf·cm kgf·cm × [L/(L+A)]
ft·lbf ft·lbf × [L/(L+A)]
in·lbf in·lbf × [L/(L+A)]
0
1
1
2
2
3
3
SST
A
L
bpe2ue00000119
1A36-1U-12L.book 8 ページ ２０１２年１２月１０日 月曜日 午前９時２５分