MECHANICAL
01-10–64
Camshaft Assembly Note
1. As shown in the figure, apply gear oil (SAE No. 90 or equivalent) or engine oil to the center area of each journal
of the cylinder head.
Caution
• Apply 0.05 ml {0.05 cc, 0.003 in
3
} or less of oil to journal No.6.
2. Apply gear oil (SAE No. 90 or equivalent) or engine oil to the following locations of each camshaft.
• Thrust surface of front journal
3. As shown in the figure, align the cam position of
cylinder No.1 around top dead center (TDC) and
place the camshafts on the cylinder head.
OIL
JOURNAL NO.6
bpe2ue00000069
INTAKE CAMSHAFT
CYLINDER HEAD
EXHAUST CAMSHAFT
bpe2ue00000070
1A36-1U-12L.book 64 ページ ２０１２年１２月１０日 月曜日 午前９時２５分
To Next Page
Loading...