MBQ-CAM-1
Auxiliary Camera
Installation
Guide
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a mobile installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
WARNING: Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment complied with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
WARRANTY
Maxxsonics, LLC. warrants this product, to the original consumer purchaser, to be free from
defects in material and workmanship for a period of one (1) year from the date of purchase.
Maxxsonics, LLC. will, at it’s discretion, repair or replace defective products during the warranty
period. Components that prove to be defective in materials and workmanship under proper
installation and use must be returned to the original authorized Maxxsonics, LLC. retailer from
where it was purchased. A photocopy of the original receipt must accompany the product being
returned. The costs associated with removal, re-installation and freight are not the responsibility
of Maxxsonics, LLC. This warranty is limited to defective parts and specically excludes any
incidental or consequential damages connected therewith. Please visit the website for full warranty.
MB Quart products are designed and engineered in the USA by
www.maxxsonics.com
MBQ-CAM-1 QSG 01 - rev1
Wiring Diagram
The wiring and connections should be secure and away from any
moving parts or extremely hot surfaces.
The yellow RCA signal output can be connected directly to the
camera input of an audio head unit.
JST CONNECTOR
P3
P2
P7
FUSE
REVERSE
TRIGGER WIRE
CAMERA/VIDEO INPUT
7
4
5
63
2
1
8
To Previous Page
Loading...
Need help?
General