3
© 2012 Mobile Climate Control
T-299 Rev. 08/2012
Table of Contents
4.6.2 Preparation 4-5........................................................................
4.6.3 Procedure For Evacuation and Dehydrating System (Triple Evacuation) 4-6.........................
4.7 PROCEDURE FOR EVACUATION AND DEHYDRATING SYSTEM 4-6............
4.8 ADDING REFRIGERANT TO A SYSTEM 4-6...................................
4.8.1 Checking Refrigerant Charge 4-6..........................................................
4.8.2 Adding Full Charge 4-6.................................................................
4.8.3 Adding Partial Charge 4-6................................................................
4.9 COMPRESSOR(S) 4-7........................................................
4.9.1 Evaporator Tie-In 4-9.. ...................................................................
4.10 TORQUE SPECIFICATIONS - REFRIGERANT FITTINGS 4-11.....................
4.11 TORQUE SPECIFICATIONS - BOLTS 4-11......................................
4.11.1 Electrical Control Panel - Torque Values 4-11.................................................
4.12 DRIVE BELT INSTALLATION 4-12............................................
4.12.1 Introduction 4-12.......................................................................
4.12.2 Belt Clearance 4-12......................................................................
4.12.3 Pulley Alignment 4-12...................................................................
4.12.4 Drive Belt Tension Guidelines 4-13.........................................................
4.12.5 Measuring Methods for Belt Tension 4-14....................................................
4.13 RETURN AIR FILTER 4-14....................................................
4.13.1 GEN 4 (EXCEL) Series 4-14..............................................................
4.13.2 GEN 5 Series 4-14......................................................................
4.14 EVAPORATOR BLOWER AN D/OR MOTOR ASSEMBLY 4-15.....................
4.14.1 GEN 4 Series 4-15......................................................................
4.14.2 GEN 5 Series 4-15......................................................................
4.15 RESISTORS 4-15.............................................................
4.15.1 GEN 4 Series (Excel) 4-15................................................................
4.15.2 GEN 5 Series 4-15......................................................................
4.16 CONDENSER FAN ASSEMBLY 4-16...........................................
4.17 REPLACING THERMOSTATIC BLOCK VALVE 4-16.............................
4.18 CHECKING AND REPLACING HIGH PRESSURE SWITCH 4-16...................
4.18.1 Replacing High or Low Pressure Switch 4-16.................................................
4.18.2 Checking High Pressure Switch 4-16........................................................
4.19 MOISTURE INDICATOR (SYSTEM) 4-17........................................
4.20 FILTER-DRIER OR RECEIVER-DRIER 4-17.....................................
SECTION 5 5-1........................................
ELECTRICAL SCHEMATIC DIAGRAMS 5-1.....................................................
5.1 INTRODUCTION 5-1.......................................................
To Next Page
Loading...
