MCCORMICK X60 Series - Interchangeable PTO Shaft

113
Operation
5
Interchangeable PTO shaft
DifferentPTOoutputshaftsareavailable:
•diameter13/8”(34.9mm.)shaftwith21splinesfor
 1000RPMpowertake-off,standardassembly(2).
•diameter13/8”(34.9mm.)shaftwith6splinesfor
 the540RPMPTO,providedwiththetractor(1).
CAUTION: Only use the PTO driveline for 540 RPM if
the implement used requires a power greater than 56
kW (75 HP) since damages to the driveline itself and
to the connected implements could injure bystanders.
Implements requiring more than 56 kW (75 HP) may
be used only with PTO drivelines at 1000 RPM, 21
splines.
Proceedasfollowstochangetheshaft:
•Removetheguard(4)
•Removethefourfixingbolts(3)andreplacetheou-
tputshaft1or2.
•Correctlytightentheforfixingboltsoftheoutput
shaft(3).
•Mounttheguardagain(4).
Aftermountingtheshaft,selectthecorrectrotation
speedbymeansoftherelativelever.
ReplacingtheinterchangeablePTOshaft.
ChangingthePTOdriveline-NAO.
1-PTOdriveline.2-Springring.
North America
1000RPM PTO with 540RPM shaft, 6 splines.
1000 RPM PTO only allowed with 1000 RPM
shaft, 21 splines.
Tochangetheoutputshaft(1),firstremovethespring
ring(2)usingsuitablepliers.
Removetheshaft.Thoroughlygreasethenewshaft
andinstallit.Makesurethatithasbeencompletely
seated.
Fitthespringringbackinplaceandmakesurethatit
ispositionedcorrectly:replaceitifitisdamagedor
deformed.
Aftermountingtherequiredshaft,usetheleverto
selectthecorrectspinningspeed.
WARNING: Do not use the 540RPM PTO driveline
if the implement requires a power over 56 kW (75
HP). A damage to the shaft or the connected imple-
ment could be dangerous for nearby persons. Imple-
ments that require more than 56 kW (75 HP) should
only be attached to the 1000 rpm PTO driveline, 21
splines.