MCCORMICK X60 Series - PTO Safety Guards; PTO Error Codes

114
Operation
PTO Safety Guards [4.2.e]
Alltractorswithapowertake-offhavealargesafetyguard
(1)andasmalltubetypeguard(2)forthesplinedoutput
shaft.Topreventinjurytotheoperator,thetractorpower
take-offsafetyguardandtheshieldsforthetelescopic
shaftassemblymustbeused.
Keeptheguardsinplace.
WARNING: Do not exceed the recommended
speeds of the driven machine. Do not oper-
ate the PTO unless the shaft and drive line
shields are in position and the tachometer is
working correctly. Read and learn to under-
stand the Operator's Manuals supplied with
any PTO driven equipment which may be
attached to the machine.
WARNING: Whenever a PTO driven imple-
ment is in operation, the PTO guards MUST
be in place during operation to prevent
injury to the operator or bystanders. Where
attachments, such as pumps, are installed
on the PTO shaft (especially if the tractor
PTO guard is moved upward or removed)
extended shielding equivalent to the PTO
guard must be installed with the attach-
ment. Install the PTO guard again to its
original position immediately after remov-
ing the attachment.
WARNING: Never drive without the PTO caps
(2) or protection (1) mounted. These com-
ponents protect the operators from injury
and the shaft splines from damage.
PTO error codes
Incaseof PTOmalfunction,theinstrument clusterwill
displayanexclamationmark.TocheckthePTOerrorcode,
refertotheErrormenuonthedigitalinstrumentcluster.
WARNING: When an operation ERROR is displayed,
ask the Dealer's specialized personnel for help
indicating the error code. The Dealer's personnel
has specific competences to locate the error and the
type of operation to be performed.