MCCORMICK X60 Series - Operating Hydraulic Motors

134
Operation
Operating Hydraulic Motors
Connecthydraulicmotorstothe1stremotecircuitto
makesureofaconstantflowofoiltothemotor.
Stoptheengine.Moveremotecontrolleverforwardto
thefloatposition.
Turnthelockingcontrol(1)fullyanti-clockwise(three
positionsfromneutral),sothatthemovementofthe
controlleverislimitedtotwopositions:retractand
float.
Inthiswaytheleverhasonlyavailablethetwoposi-
tionstobeusedwithhydraulicmotors.
Toengagethehydraulicmotor,starttheengineand
movethecontrolleverforwardfromthefloatposition
untilagainsttheleverlock.Thehydraulicmotorwill
nowoperate.
Todisengagethehydraulicmotor,movetheremote
controlleverforwardtothefloatposition.Waitforthe
hydraulicmotortoslowlystop.
DONOTDISENGAGETHELEVERLOCK.Allowingthe
controltoreturntotheneutralpositionduringmotor
applicationwillcausethemotortostopimmediately.
Thismaycausedamagetothehydraulicmotor,hoses
andequipment.
Tochangethedirectionofrotationofthehydraulic
motor,changethehosesoveronnumber1remote
coupler.
IMPORTANT: To avoid damages to hydraulic pumps in
tractors, all hydraulic fluid flowing back from all imple-
ments must be returned through the return circuit of the
hydraulic motor.
Free discharge - Hydraulic Motor
Return Circuit (if equipped)
Thehydraulicmotorreturncircuitcanbeusedto
reducerestrictionintheremotehydraulicmotorreturn
line.Thiswillresultinmoreefficienthydraulicmotor
operation.
Tousethehydraulicmotorreturncircuit,connectthe
returnlinefromthehydraulicmotororimplementtothe
connector(1).