MCCORMICK X60 Series - Front Power Lift; Hitch System; Multi Valve; Valve Positions

137
Operation
5
Hitch System
Thefrontpowerliftisoperatedviathetractor’sremote
hydraulicvalvecircuitandisdoubleacting,(thelinkage
ispowerliftedandpowerlowered).
ThehitchisdesignedforCategoryIIINimplements.
Thetoplinkhasaballend.
MaximumLiftCapacity............................................2800kg
IMPORTANT: Do not exceed the maximum permitted
front axle operating weight when using the front hitch.
Observe tyre load capacities and any possible legal
limitations.
FRONT POWER LIFT (if equipped) [4.2.g]
DECAL
(Ifequippedwithafronthitch-
Locatednearthemulti-purpose
controlvalve)
Read the Operator’s Manual
carefully before using.
Multi Valve
Thevalveismountedattherearofthetractor.
Themultivalvehastwooperationmodes.
Valve Positions
1st mode - Double acting
2nd mode - Single acting
3rd mode - Disengaged (Transport)-Forsystemsafety
duringtransportortravelonroad.
IMPORTANT: The front power lift is operated using
one of the tractors remote valves. In order to use the
rear couplers of this valve the front power lift MUST be
disengaged as shown.