Operation
144
PICK UP HITCH
(if fitted, on request on certain markets)
Two types of pick-up hitches are available.
-Mechanical
-Hydraulic-Connectthehosesofthehydraulicpick-
uphitchtotherearhydraulictaps(1)oftheauxiliary
hydraulicvalvetobeused.
PickUpHitch
Connecting an implement
OPERATION1
Electronic Power Lift System
TurntheUpperLimitControlKnob(4)tothemaximum
setting.
- Raisethethree-pointlinkagebyturningtheswitch(1)
toPos.C.
- Settheselector(3)topositioncontrolmode(Pos.1)
byturningitinananti-clockwisedirection.
- Setthedown-speedselector(6)toposition(0)(lock)
topreventanyaccidentalloweringmovementshould
thecontrolsbeaccidentallyoperated.
WARNING: If the control switch (1) is
moved to the links down position (A) and
the work height control knob (2) is moved,
the arms can be lowered. Set the lowering
speed control (6) to Pos. 0 (padlock) to pre-
vent any accidental movement.
Maxim um p er mi tted operating
weights
WARNING: comply with the max. load capacity
of the automatic hitch and of the drawbar. Do
not work with loads greater than the maxi-
mum allowed ones. This could damage the
automatic hitch and the rod. It also reduces
stability of the front part.
Maximum loads on axles also depend upon the
capacity of the rear tyres fitted. For maximum
allowed loads, see the “Technical specifica-
tions” Section.
Ask your Dealer for further information.
WARNING: The automatic Pick-Up Hitch
and pulling trailers on public roads is not
permitted unless a special approval note has
been supplied with the machine documents.
Ask your Dealer for further information.
WARNING: Pick-Up Hitch hook (PUH) - The
coupling and uncoupling of the PUH must
be made strictly with the lifting device in
a controlled position to ensure the proper
functioning of the fastening/release of the
hook.