MCCORMICK X60 Series - Hook;Drawbar Change over

Operation
146
OPERATION10
Lowerthehitchontothelockinglatchestotaketheweight
offthehydraulicsystem.
IMPORTANT: The hitch must always be supported on
the locking latches and NOT by the hydraulic system.
If the locking latches do not lock, adjust the lift rods. If
after adjustment the locking latches still do not lock see
your dealer.
IMPORTANT: To prevent accidents, make sure the
hook is fully retracted and the frame is correctly latched.
Hook/drawbar change over
(iffitted,onrequestoncertainmarkets)
OPERATION1
Lowertheautohitchhalfway.Extendthehitch/drawbar
bymovingthecorrespondinghydraulicremotecontrol.
IMPORTANT: After lowering and extending the auto
hitch, stop the engine, and engage the parking brake
before leaving the tractor.
OPERATION2
Removethehitch/drawbarlocatingpins.
OPERATION3
Removethehitchor drawbar.Stowawaytheremoved
hitchordrawbarinasuitablerecessfortransport.
Installthehitchordrawbar..
Installthelockpins.
Retractthehydraulichitchandraisethepick-uphitchuntil
locked,thenlowerontolatches.
WARNING: BEFORE DRIVING OFF AND
AFTER THE COUPLING, MAKE SURE THE
LOCKING HITCH IS FULLY RETRACTED AND
THE FRAME IS CORRECTLY LATCHED.