MCCORMICK X60 Series - Adjusting Wheel Track; 4 WD Axle - Adjusting Wheel Track

158
Tyres, Wheels, Ballasting
Adjusting wheel track
4WD axle - Adjusting wheel track
Thefronttrackon4WDtractorscanbeadjustedbychan-
gingthepositionofthehubsandcentralwheeldiscsas
showninthetablebelow.
Makesurethatthewheelnutsarecorrectlytightenedto
theprescribedtorquewrenchsetting:
Disktohub:270Nm
Rimtodisk:210Nm
IMPORTANT: After removing and fitting the wheels back
again, it is important to check the torques of all bolts by
means of a torque wrench at the following intervals:
- First check after 10 work hours.
- Second check after 50 work hours.
- Third check and further checks every 500 work hours.
WARNING: When you lift up the tractor to
adjust the wheel tracks, follow the directions
for lifting in the Safety Notes section.
WARNING: Maximum attention must be used
when dismounting the front wheels: because
of their weight, a suitable hoist must be used
to remove and handle the wheels.