MCCORMICK X60 Series - Adjusting Rear Track Widths - Rim and Disc Position; Wheel Disc Pointing Inwards; Wheel Disc Pointing Outwards; Rear Track Width Adjustment

160
Tyres, Wheels, Ballasting
Rear track width adjustment
The rear track width can be adjusted by changing the
positionoftherimfixingpointsorthecentralwheeldiscs,
asshowninthetablebelow.
Torquethenutsandboltsthatfixtherimtothediscto
240Nm(1)andthosethatfixthedisctothewheelhub
to320Nm(2).Alwayschecktyrepressure.
Certaintrackwidthscannotbeobtainedwithsometyre
types(seetable).
Adjustingreartrackwidths-Rimanddiscposition
 Wheeldiscpointinginwards Wheeldiscpointingoutwards
 A E
 B F
 C G
 D H
WARNING: When you lift up the tractor to
adjust the wheel tracks, follow the directions
for lifting in the Safety Notes section.
WARNING: Maximum attention must be used
when dismounting the rear wheels: because
of their weight, a suitable hoist must be used
to remove and handle the wheels.
IMPORTANT: After removing and fitting the wheels back
again, it is important to check the torques of all bolts by
means of a torque wrench at the following intervals:
- First check after 10 work hours.
- Second check after 50 work hours.
- Third check and further checks every 500 work hours.