MCCORMICK X60 Series - Filter on the Delivery of the Steering Circuit

197
Maintenance
7
9
250 HOUR MAIN SERVICE
Filter on the delivery of the steering
circuit.
WARNING: Change the paper filter on the delivery
after the first 50 hours service and then after every
250 hours.
Also change the filter whenever the red indicator
lights on the instrument panel come on.
Changetheelementof the filteronthedelivery of the
steeringcircuit:
a- Unscrewtheholder(1),removeanddiscardthefilter
element(3).
b- Fit the new filter element (3) into the cover of the
filter(2).
To prevent the filter element from being dirtied (with
mud,etc.)onlycompletelyremovetheplasticprotection
afterfitting.
c- Mounttheholder(1)afterhavingoiled itsthreaded
part,thewasher(4)andseal(5)withcleannewoil.
Takegreatcaretofittheindividualpartsintheright
directions.
Change the seal (5) and the washer (4) every 1000
hours service or whenever necessary.
d- Fullyscrewontheholder(1)byhand.
NOTE: After changing the oil and filters, run the engine
for a while and make sure there are no leaks. Check the
oil level again and top up if necessary.
NOTE: Use the oil indicated in the Lubricants and Fuels
chart.
NOTE: Make sure that the hydraulic equipment con-
nected to the tractor’s hydraulic circuit uses the same
type of oil. Use of different types of oil could damage
the hydraulic circuit.
Oilfilteroftransmissionandofthesteeringandpower
liftcircuits.
1-Holder.
2-Cover.
3-Filterelement.
4-Washer.
5-Seal.
WARNING: Always use specific personal safety devices
for each operation. Beware of burns caused by hot
tractor parts. [4.1.n]