MCCORMICK X60 Series - Remove Air from Fuel System - Electronic Engine

204
Maintenance
500 HOUR MAIN SERVICE
Remove Air From Fuel System - Electronic engine
X60.50
Aircanenterthefuelsysteminthefollowingsituations:
A.Ifthefueltankbecomesemptyorislowonfuel.
B. Afterfuelsystempartshavebeenremovedforservice
orrepairs.
C.Ifthetractorhasbeenin agarageforalong period
oftime.
IMPORTANT: DO NOT crank the engine before removing
all the air from the fuel system or the fuel injection pump
can be damaged.
Mod.X60.50
OnMod.X60.50tractorsusethefollowingprocedureto
removeairfromthefuelsystem.
OPERATION1
Makesurethereisfuelinthetank.
TurnthekeyswitchtoONtoenergizethecutoffsolenoid.
OPERATION2
Operatethehandprimerpump(1)untilpressureisfelt
againstthepump.
OPERATION3
Starttheengineandcheckforfuelleaksaroundthefilter,
thefuellinesandfittings.
Iftheenginefailstostartoperatethehandprimerpump
again.Iftheenginestillfailstostartseeyourdealer.
WARNING: Never start the engine in a closed
building. Proper ventilation is required un-
der all circumstances.
WARNING: If you need to open the bonnet, follow the
procedure indicated under “How to open the bonnet”.
Two persons are required to carry out this operation
safely.
Shiftthegeartoneutralandengagetheparkingbrake.
WARNING: Always use specific personal safety devices
for each operation. Beware of burns caused by hot
water and engine parts. [4.1.n]