MCCORMICK X60 Series - Transmission Housing; 4 WD Steering Cylinder Knuckle Joints

209
Maintenance
7
9
1000 HOUR MAIN SERVICE
Oil changes for the transmission,
steering circuit and power lift
hydraulic circuit, rear final drives.
NOTE: It is advisable to change the oil for the first time
after 500 hours. After this, change the oil after every
1000 hours service.
Transmission housing
1- Lowertheliftarmstotheground.
2- Removetheplug(2).
3- Placevesselsunderall sevendrainplugsto collect
theoilasitdrainsout.
4- Removethe plugs under transmission housing and
drainouttheoil.
 Removetheplug(4)fromtheright-handandleft-hand
rearfinaldrivestodrainoutalloil.
5- Fitthedrainplugsbackinplace,thenpouroilofthe
approvedtypeintothetransmissionuntilthecorrect
levelhasbeenreached(3).
NOTE: Let the oil stabilize before checking its level.
WARNING: See the Lubricants and Fuels chart for the
type of oil to be used according to the transmission
type.
4WD steering cylinder knuckle
joints
Havetheknucklejointnuts(1)checkedbyanauthorized
servicecenterafterthefirst50hoursandthenafterevery
1000hoursservice.
WARNING: Always use specific personal safety devices
for each operation. Beware of burns caused by hot
tractor parts. [4.1.n]