MCCORMICK X60 Series - Display MENU; Operating Menu

65
Instruments and Programming
4
Display MENU
Themenusystemfortheclusterisoperatedbyusingthethreebuttonsontheleft-handpanel.
UP
DOWN
MENU
Themenusystemisdividedinto2parts:
1-Operatingmenu
AccessedbyusingtheUP/DOWNarrowswhenthekeyison.
2-AccessoriesMenu
IsshownautomaticallywhenthekeyisturnedtotheAccessoryposition.
1.1 Operating menu
Whentheignitionison,eitherwithorwithouttheenginerunningtheWorkingMenucanbecycledthroughbyusingthe
UPandDOWNbuttons.
Afterkey-ontheclusterwillalwaysdefaulttothePTO/hoursscreen.AssoonasEnginespeedgoesabove500RPMfor
morethan2seconds,thedisplaywillshowthelastselectedworkingmenuoptionbeforepreviouskeyoff.
ThediagrambelowshowsthemenupathwhenusingtheDOWNbutton,ifUPispushedthedirectionisreversed.
NOTE: Count of worked area is active only if the engine is running and implement width is set on a value different from “0”.
1)Powertake-off/hours
2)Workedarea
3)Distance
4)Calibration
5)Worktimer
6)Vehicleerrors-ifactive