MCCORMICK X60 Series - Distance Travelled; Manual Mode

69
Instruments and Programming
4
1.1.3 Distance travelled
IfthedownbuttonispushedagaintheDistanceTravelledmenuisselected:
Thescreenshows:
Time-13:24
Distanceunitsselected-Km
Distancetravelled/worked-208.3Km
PTOmodecurrentlyselected-1000Rear
PTORPM-0
ThearrowindicatestheDistancemenuisselected.
Ifthecounterisoperating,thisarrowwillflashwhenthemenuisselected.
Each time the menu is selected, the counter will display "AUTO" or "Man"
(MANUAL)2secondslongbeforedisplayingtherelative
value.Theoperatoristhusinformedaboutthesettingsactuallyactive.
Use:
- The first screen shows the distance travelled/worked
intheunitspresetintheAccessorymenu.Toindicatea
distanceshorterthan1mile/1km,thedisplayshowsthe
followingsymbolcorrespondingtothe5thdigit:
-Onedecimalplacewillbeshownuntiltheamountof
unitsreaches9999.9,atthispointthecounterwillshow
avalueof10000.
If99999isexceededthecounterwillreset.
-Countercanworkintwodifferentmodes.Modeselec-
tionisavailableintoAccessorymenu(seeAutoFunction
Settings):
Manual Mode (Distance Travelled): when activated
by the operator, the counter counts every time the
tractors is moving until the operator stops it.
AutoMode(DistanceWorked):thecounterstartstocount
whenthetractorismovingandeitherthehitchisdown
ortheRemoteimplementswitchison.

AutoandManualmodewillincrementthesamecounter
value.
CounterActivation:
-PushingtheMENUbuttonforlessthan2secondsstarts/
stopsthedistancecounter(onlyforManualmode).
-Pushingthemenubuttonforlongerthan2secondswhen
selectedbutnotactiveresetsthecounter,
- if pushed for longer than 2 seconds when active the
counterwillstop(onlyforManualmode).
-IftheUPorDOWNarrowsarepressedtochangethe
menufunctionselectedwhenthecounterisactiveitwill
continuetocount.
-Toturnthedistancecounteroffafterexitingthemenuthe
operatorwillhavetogobackintothisscreenandpress
themenubutton(onlyforManualmode).
-Ifactiveatkey-offtheunitwillstartagaincountingat
key-on(onlyforManualmode).