MCCORMICK X60 Series - Calibration Menu

70
Instruments and Programming
1.1.4 Calibration Menu
IfthedownbuttonispushedagainthetopleveloftheCalibrationmenuisselected:
Thescreenshows:
Time-13:24
Calibrationmenuselected
PTOmodecurrentlyselected-1000Rear
PTORPM-0
ThearrowindicatestheCalibrationmenuisactive.
Use:
-AftertheCalibrationmenuhasbeenselected,bypressingtheMENUbuttontheoperatorcanchoosewhichcontroller
tocalibrate.
Thefollowingscreenisshown:
Theinstrumentclusteristhefirstdefaultcontrollertobecalibrated.
Afterenteringthismenu,youmaydisplaythecalibrationstatebymeansofthebottom
partonthedisplaythatnormallyshowsPTOspeedrate.
WARNING: The operator may only perform the calibrations quoted in the Opera-
tor column in the following table. The operator MAY NOT perform the operations
quoted in the column NOT FOR THE OPERATOR. They may only be performed by
specialized technicians at the Dealer's.