MCCORMICK X60 Series - Work Timer Menu

73
Instruments and Programming
4
1.1.6 Work timer menu
IfthedownbuttonispushedagaintheWorkTimermenuisselected:
Thescreenshows:
Time-13:24
WorkTimer-0minutes,0seconds
PTOmodecurrentlyselected-1000Rear
PTORPM-0
ThearrowindicatestheWorkTimermenuisactive.
Each time the menu is selected, the counter will display "AUTO" or "Man"
(MANUAL)2secondslongbeforedisplayingtherelativevalue.Theoperator
isthusinformedaboutthesettingsactuallyactive.
Use:
-WhentheTimermenuisfirstenteredthedisplaywillshowthescreenaboveontheright.
-Thetimerwillshowminutesandsecondsupto99minutesand59seconds.
-Whenthetimerreaches99minutesand59secondsitwillautomaticallychangetoshowhoursandminutes,andan‘h’
willbedisplayedontheleft-handside.
-Ifthetimerisallowedtoruncontinuouslyto99hoursand59minutesitwillresetto00:00andthenthecountwillstart
again.