MCCORMICK X60 Series - Mph;Kph; To Change to Metric Units

79
Instruments and Programming
4
2.1.1 MPH/KPH
ThedefaultfirstpartoftheaccessorymenuisusedtosettheunitsforDistanceTravelledandVehicleSpeed.Theunits
canbeKilometresorMiles.
Thedisplaysectionusuallyreservedtotheclockshows"AC",tosignifythemenuisaccessed,andthenanumbertoshow
thepartofthemenucurrentlybeingviewed.
This first screen shows the units currently selected, in the example above this is Miles. Both the Mi for the
distance covered and the MPH for vehicle speed are showing on the display.
Tochangetometricunits:
1-PresstheMENUbutton
2-TheMIandMPHwillflash
3-PressUPorDOWNtoscrollbetweentheoptions.
4-TheKMandKPHwillnowbeflashing.
5-TosavethisnewsettingpressandholdtheMENUbuttonforlongerthan2seconds(thesymbolswillstopflashing)
andpresstheUPandDOWNbuttonstoaccessotherpartsofthemenu.
- Ifthekeyisturnedtotheoffpositionbeforethenewvalueissettheoldvalueisused.
-AnyvaluessavedintheDistanceTravelledmemorywillbeconvertedtothenewunits.