MCCORMICK X60 Series - Implement Width; To Change the Implement Width; If the Units Need to be Changed

83
Instruments and Programming
4
2.1.4 Implement Width
PresstheUPbuttontogotothenextmenusection,thatisusedtosettheimplementwidth.Thisvalueisusedtoalong
withthedistancetravelledtocalculatetheAreaWorked.Whentheclusterisbrandnewthedefaultvalueshouldbe0=
0,0centimetres.ThewidthcanbesetinFeetorCentimetres.
Thisfirstscreenwillshowthecurrentsettingandunits,30.0Feetintheexample.Agraphicisshownatthebottomof
thescreentosymboliseimplementwidth.
Tochangetheimplementwidth:
1-PresstheMENUbutton
2-Theactualimplementwidthwillflash(e.g.30.0).
3-pressUPorDOWNtoscrollmetricunitsindivisionsof10between0000and9990.Therangeofimperialunitswillbe
0to199.5indivisionsof0.5.
 IftheMENUbuttonispressednow,youcandirectlysettheunitofmeasurementasheredescribed.
4-TosavethisnewsettingpressandholdtheMENUbuttonforlongerthan2seconds(thenumberswillstopflashing)
andpresstheUPandDOWNbuttonstoaccessotherpartsoftheAccessorymenu.
Iftheunitsneedtobechanged:
1-PresstheMENUbutton
2-Theactualimplementwidthwillflash.
3-PresstheMENUbuttonagainandtheunitswillflash.
4-PressUPorDOWNtoswitchbetweenmetricandimperial.
 F=FeetC=Centimetres
 IftheMENUbuttonispressednow,youcandirectlysetthewidthasheredescribed.
4-TosavethisnewsettingpressandholdtheMENUbuttonforlongerthan2seconds(theletterwillstopflashing)and
presstheUPandDOWNbuttonstoaccessotherpartsoftheAccessorymenu.
Note:PressMENUagainafterstage3toreturntowidthadjustment.
- Ifthekeyisturnedtotheoffpositionbeforethenewvalueissettheoldvalueisused.