MCCORMICK X60 Series - Auto Function Settings; To Change the Auto Function Settings

87
Instruments and Programming
4
2.1.12 Auto Function Settings
PressingUPagainwillgototheAutoFunctionsettingmenu,todefineifareaworked,distancetravelledorworktimer
counterneedstobesetasmanualorautomode.Thismeansthatallthesecounterswilldependfromthepositionofthe
hitch(automatic)orfromthestart/stopmenubutton(manual).Whentheclusterisbrandnew,thedefaultvalueshould
beManualforallthefunctions.
Thefirstscreenisthefollowing:
dependingonthecurrentsettingsofAreaworked(Auto/Man)."AFu"meansAutoFunction.
TochangetheAutoFunctionSettings:
1-PresstheMENUbutton
2-Thearrowbelowareaworkedsymbolwillstarttoflash.
3-PressUPorDOWNtoswitchbetweenAreaWorked,DistanceTravelledandWorkingTimeCounterwitharrowstill
flashingundertherelevantsymbol.Thefollowingscreenshouldappear(dependingoncurrentsettings-Auto/Man)
4-Oncetherightsub-menutobemodifiedhasbeenselected,pushMenubuttonagainandtherelevantAuto/Mantext
(dependingoncurrentsettingssaved)willstarttoflashwhilstarrowwillgosteadyon.
5-pressUPorDOWNbuttontochangethesettings.
6-TosavethisnewsettingpresstheMENUbutton,thetextwillstopflashing,thearrowwillflashagainandyougoback
topoint3.
7-PressingtheUPandDOWNbuttonswillnowaccesstheothersub-menuoftheAccessorymenu.
8-PressingandholdingtheMENUbuttonlongerthan2seconds,youmayinanymomentsavethecurrentsettingsand
quitthemenu.PressingtheUPandDOWNbuttonswillnowaccessotherpartsoftheAccessorymenu.
IfthekeyisturnedtotheOFFpositionbeforethenewvalueisset,theoldvalueisused.