MCCORMICK X60 Series - Clock Setting; To Change Clock

89
Instruments and Programming
4
2.1.14 Clock setting
PressingUPagainwillenabletheoperatortosettheclock.PressingDOWNfromtheAC:1originalscreenshotwillalso
reachthissection.Theclockcanalsobesettobe12or24hoursinthismenu.Whentheclusterisbrandnewthedefault
valuesshouldbe24hand00:00.
Thisfirstscreenwillshowthecurrenttime(22:48)andwhethertheclockissetto12or24hours(24h).ThelettersCLC
willshowatthebottomoftheleft-handdisplaytoinformtheoperatorthisistheClockSettingmenu.
TochangeClock:
1-PresstheMENUbutton
2-Thehourdigitswillflash.
3-PressUPorDOWNtoscrollinunitsof1from00to12or24.
4-PresstheMENUbuttonagaintosetthehours.
5-Theminuteswillflash.
6-PressUPorDOWNtoscrollinunitsof1from00to59.
7-PresstheMENUbuttonagaintosettheclockon12or24hours.
8-Thetextinthemiddlelinewillflash.
9-PressUPorDOWNtoswitchbetween12hor24h.
10-AtthispointthetimecanbesavedandthemenuexitedbypressingandholdingtheMENUbuttonforlongerthan
2seconds(thedigitswillstopflashing),thenpresstheUPandDOWNbuttonstoaccessotherpartsoftheAcces-
sorymenu.
Ifthekeyisturnedtotheoffpositionbeforethenewtimeissettheoldvalueisused.