EasyManua.ls Logo

MCCORMICK X60 Series - Starting Procedure

MCCORMICK X60 Series
262 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
93
Operation
5
OPERATION3
XTRASHIFT
ShifttheF/N/RlevertoNEUTRAL.
NOTE: XtraShift tractors are equipped with a neutral start
switch in the reverse shuttle circuit. However, if the For-
ward/Neutral/Reverse lever is not on neutral, the engine
will NOT start.
OPERATION4
Checkthattheengagementswitch/leverofthePTOclutch
isinthedisengagedposition.
FortractorswithfrontPTO,disengagethecontrolswitch.
Checkthattheauxiliarycontrolvalvesleversarein
neutralposition.
NOTE: The engagement switch/lever of the rear PTO
clutch MUST be in the disengaged position or the starter
motor will not operate.
To next page...
WARNING:Theenginemaybestartedonlyin
theconditionsgivenhereunder.Ifthisfailsto
occur,havethetractorrepairedbyyourDealer
orauthorizedservicecentre.
WARNING:Onelectricallyoperated4WDtrac-
tors,the4WDclutchisspringloadedintoen-
gagementandreliesonhydraulicpressurefor
disengagement.Afailureinthe4WDhydraulic
systemwillthereforeautomaticallyengage
the4WDeventhoughthe4WDswitchisinthe
disengagedposition.Thisisabuiltinsafety
feature.DONOToperate4WDtractortransmis-
sionswiththerearwheelsoffthegroundorre-
moved,UNLESSTHEFRONTWHEELSAREALSO
JACKEDUPCLEAROFTHEGROUNDORTHE
FRONTAXLEDRIVESHAFTISDISCONNECTED.
Failuretodothiscanresultinthetractorbeing
pulledofftherearsupportsbythefrontaxle.
WARNING:Operatecontrolsonlywhenseated
intheOperator'sseat.
IMPORTANT: Set the engine rpm to low idle
for a few minutes to make sure that enough lubricant
reaches the turbocharger bearings and engine parts
before operating the engine at a high rated speed.
OPERATION1
MakesuretheMasterDisconnectSwitch(ifequipped)is
intheONposition.
OPERATION2
Fullydepresstheclutchpedal.Shifttherangeleverand
thegearlevertotheNEUTRALposition.
NOTE: The gearshift lever MUST be in NEUTRAL, or the
starter motor will not operate.
STARTING PROCEDURE [4.1.c]
WARNING:Thetractormustonlybestarted
withtheauxiliaryvalveleversareinneutral.

Table of Contents

Related product manuals