MCCORMICK X60 Series - Parking the Tractor

97
Operation
5
Use of accessories with the tractor at standstill
(with engine running)
BeforeoperatingthePTOorthehydraulicsysteminany
way,proceedasfollows:
OPERATION1
     
XTRASHIFTTRACTOR
Stopthetractorandbringtheleverofgearboxwithreverse
shuttletotheNEUTRALposition.
OPERATION2
     
Presstheclutchpedalandputintoneutralboththerange
leverandthegearshiftlever.
PARKING THE TRACTOR [4.1.c]
Turning off the engine
-PerformthepreviousOperatione1and2.
OPERATION3
DisengagethePTOclutchcontrol,ifinuse.
OPERATION4
     
Bringthethrottleleverfullybacktotheidlepositionand
lettheengineidle.
Applytheparkingbrake.
EngagetheParkLock(ifequipped).
OPERATION5
TurnthekeyswitchtotheOFFpositionandremovethe
key.
IMPORTANT: When stopping the engine after operat-
ing under heavy load, run the engine at idle speed for
a short period of time. This will allow the engine and
turbocharger temperature to decrease gradually.
WARNING: whenever the tractor is left unattended,
the ignition key must be removed.
OPERATION6
Turnoffmasterdisconnectswitch(ifequipped)andre-
movethemasterswitchkey.