McIntosh C220 - REMOTE CONTROL - Page 6

6
Volume Lock
Once you have completed learning all keys, press and
hold SETUP until
the LED blinks twice to save all data learned.
Deleting a Single Learning Key
This process returns the key to its original program-
ming for the mode you
select. You can also delete learned programming by
teaching a different
function to the key (see “Programming a Learned
Key”).
NOTE: If more than 10 seconds pass between key
presses, the remote exits programming.
1. Press the mode key that you wish to remove the
learned key from.
2. Press and hold SETUP until the LED blinks twice,
then release.
3. Enter 9 7 6. The LED blinks twice.
4. Press the key containing the learned function to be
deleted twice. The
LED blinks twice and exits from programming.
Deleting All Learned Keys in a Specific Mode
NOTE: If more than 10 seconds pass between key
presses, the remote exits
programming.
1. Press and hold SETUP until the LED blinks twice,
then release.
2. Press 9 7 6. The LED blinks twice.
3. Press a mode key twice (i.e., TV. VCR/DVD, CBL/
SAT, etc.) to clear all the
learned keys for that mode. The LED blinks twice and
exits from programming.
CHANGING VOLUME LOCK
The Potenza universal remote control comes preset to
allow independent
volume control of each selected device (Global Vol-
ume Unlock). However, you
may change the Volume Lock setting to Global Vol-
ume Lock so that one
device’s volume will control volume in all other
modes. After that, you can
perform Individual Volume Unlock on a selected de-
vice to set its volume
control for independent operation or Global Volume
Unlock to remove all
volume locking.
Locking Volume Control to One Mode (Global Vol-
ume Lock)
1. Press and hold SETUP until the red LED blinks
twice, then release.
2. Enter 9 9 3, the LED blinks twice.
3. Press the mode key for the device you want to con-
trol (for example, TV).
4. The LED blinks twice. Now when you press VOL+,
VOL-, or Mute, the
selected device (for example, TV) controls the volume
regardless of the
current mode.
Unlocking All Volume Control (Restoring Global
Unlock)
1. Press and hold SETUP until the red LED blinks
twice, then release.
2. Enter 9 9 3, the LED blinks twice.
3. Press VOL+. The LED blinks four times. Volume is
independently
controlled for all programmed components.
Unlocking a Single Device’s Volume Control
1. Press a device key (TV. VCR/DVD, CBL/ SAT,
etc.).
2. Press and hold SETUP until the red LED blinks
twice, then release.
3. Enter 9 9 3. The LED blinks twice.
4. and then press VOL-. The LED blinks four times.
Volume is independently controlled for the selected
components.