I
I
I
I
MDR-2000 VJ User's Reference Manual
Interactive Monitor
If
a valid date cannot be determined then all calls are discarded. This feature is valid in
CDR
configurations only.
SET
DESCRETE
COLLECTION
FUNCTIONS
- This command enables and disables the
ability
of
the MDR-2000 to selectively transmit
CDR
data and/or image data.
If
this command is
set to
'No
',
which is the default setting, then when being polled the MDR-2000 will transmit both
CDR
and image data intermixed. The
MDR
data collection programs will separate the data for the
user when it is received at the host computer.
If
set to 'Yes' then the polling software can selectively determine that it wants only the
CDR
or
image data. This feature allows the
CDR
data to be polled by one host computer and the image
data to be polled by another host computer. The data collection commands used in this process are
'CA',
'CI'
and
'CC'.
SET
DIGITS
- This option sets the minimum number
of
digits that be dialed before the call is
stored. Calls with this number or fewer digits are discarded unless they begin with a sequence
of
digits contained in the retention table. The default value
of
'O' accepts all calls. This feature is
valid in
CDR
configurations only.
SET
DURATION
- This option set the minimum call duration in seconds.
If
a call is placed which
has a duration equal to or less than the number
of
seconds in this setting then the call is discarded.
The default value
of
'
O'
accepts all calls. This feature is valid in
CDR
configurations only.
SET
EXT->EXT-This
command accepts either a 'Yes' or
'No'
argument.
If
set to ' Yes' then
calls with an Originating ID Type
of
'D' and a Terminating ID Type
of
'
D'
which makes them
internal calls, will be retained.
If
'
No'
then these calls will be discarded. The volume
of
calls
retained could increase dramatically
if
this setting is ' Yes' so caution should be used to ensure that
the MDR-2000 has sufficient capacity to handle the volume. The default setting is '
No
'.
SET
HELP
- This option causes a list
of
the
SET
options to be output.
SET
IDLE
- SET IDLE PBX <Value> - Sets an alarm interval which monitors
PBX
activity.
If
the
interval elapses with no output from the
PBX
then a single carriage-return character (ASCII
ODH)
is output to the
PBX
and the response monitored.
If
there is no response after 2 seconds then an
M2KIDL error message is annunciated. The
SET
ALARM command must
be
used to enable alarm
annuncation. The range is between 0 and 59 minutes, the default is 0 which indicates the feature is
disabled.
SET
IMAGE
-This
option accepts either a '
Yes'
or
'No'
argument.
If
'Yes'
then the data rejected
by the selective CDR processing routines is stored in its image form, otherwise this data is rejected.
5-11
To Next Page
Loading...