Me-Mover Speed - How to Use Quick Releases

7
ME-MOVER.COM
WARNING!
Always ensure that the quick releases are securely tightened suciently. If they come
loose you must re-adjust the quick release to make it tighter. Never drive the
Me-Mover Speed without having tested that your quick releases are correctly
mounted and secured.
WARNING!
To close the clamp you must use a fair amount of force, otherwise it may be too
loose.
OPEN position CLOSED position
Adjustment
screw
Washers
Screw
Clamp
NOTE: When in open position, the adjustment screw needs to be adjusted so that closing
the quick release requires some force to close the clamp. The narrow part of the spring
should point towards the wheel, as illustrated.
Springs
HOW TO: USE THE QUICK RELEASES
The Me-Mover Speed has two quick releases. It is extremely important that these
quick releases are tightened securely before you use your Me-Mover Speed.
Front wheel quick release: used to secure the front wheel to the front fork.
Steering column quick release: used to adjust the height of the steering column. It can
be adjusted to suit a child or an adult.
To ensure the tightness of a quick release you need to:
1. Hold the clamp OPEN while you rotate the nut in a clockwise direction.
2. Rotate the nut until you cannot close the clamp anymore.
Then release the nut slightly so you can JUST close the clamp.
3. To close the clamp push it rmly inwards.
Grease can help to
smoothen the open/close
procedure