Battery installation
• Remove the screws from the battery compartment with a
small Phillips screwdriver.
• Set the channel 1 through 5. The switch is located in the
battery compartment. Channel 1 is typically selected if only
one remote thermo-hygrometer is being used.
• Install 2 "AA" size alkaline batteries (not included)
matching the polarities shown in the battery compartment.
• Replace the battery compartment door and secure the screws.
• Secure the remote thermo-hygrometer in the desired location.
Mounting
• The remote thermo-hygrometer can be placed on the flat
surface or mounted on the wall in vertical position
• Use the wall mount hardware and screws provided when
mounting the remote thermo-hygrometer on the wall
Placement tips:
• The remote thermo-hygrometer should be placed in the area
with a free air circulation and sheltered from the direct
sunlight and an extreme weather conditions.
• Ideally, place the remote thermo-hygrometer above the
natural surfaces (such as a grassy lawn).
• Avoid placing the remote thermo-hygrometer near sources
of heat such as chimneys and heating elements.
• Avoid any areas collecting and radiating a heat from the sun,
such as metal, brick or concrete structures, paving, patios
and decks.
• The international standard for the valid air temperature
measurements is 4 feet (1.25meters) above the ground.
Note: To display the readings from the remote thermo-
hygrometer you must own the main display unit of the
Meade Professional Weather Station TE923W-M, model
number TE923W-M. Additionally it will work with all other
Meade weather station models.
6
To Next Page
Loading...