Page 2 Version 4
Step 3 – The machine comes set to White Flyer “BIO” clays. If using something
different you will need to check the height / clearance of the knife-edges by
placing a clay in the carousel. Rotate the carousel so that the clay starts to pass
underneath the inner and outer knife separator blades. The clay must pass freely
under the knife separator blades without binding but with the minimum of
clearance. Adjust if necessary with 7/16” open ended wrench. The height on both
the inner and outer knife edge will need to be adjusted. Photos below show
adjustment with carousel fitted, but you can remove the carousel to make
adjustment easier if preferred.
Step 4 – Now, you can lay out the battery terminals and control box at the back
of the machine. DO NOT CONNECT BATTERY AT THIS POINT.
To Next Page
Loading...
