To Next PageTo Next PageWhy is my MediaShop Fitness Equipment remote control not working?
If your MediaShop Fitness Equipment remote control isn't working, there are a couple of potential reasons: * The batteries might be weak, in which case you should change them. * The remote control might be too far away from the device’s infrared sensor. The infrared signal’s range is two metres.
What to do if my MediaShop VibroShaper remote control can’t be used to stop the device?
If the remote control can’t be used to stop the device while it is running, it could be due to the following reasons: * The batteries are weak, so try changing them. * The On/Off button has been pressed. In this case, press the Start/Stop button.
What to do if my MediaShop VibroShaper device is not running?
If your MediaShop Fitness Equipment device is not running, check the following: * Ensure the cable is plugged into a socket. * Make sure the power switch is in the ON position.
Why did my MediaShop Fitness Equipment device suddenly stop running?
If your MediaShop Fitness Equipment device suddenly stopped running, it may be because the end of the programmed exercise period has been reached. In this case, reset the exercise period.
General| Brand | MediaShop |
|---|---|
| Model | VibroShaper |
| Category | Fitness Equipment |
| Language | English |
