measured goal are at the right angle.
Press this key briefly, this symbol is displayed in
the screen. According to the on-screen prompts,press
to take right angle edge - right angle, or bevel edge - right angle
edge operation then the instrument will automatically realize
Pythagorean operation, the result is displayed in the main
display area.
·When measuring in Pythagorean measurement mode,
right-angle edge length must be less than the length of the
hypotenuse, otherwise the equipment will report mention
information.
· Under the Pythagorean measurement mode, make sure to start
the measurement from the same starting point. In hypotenuse -
right angle edge model, it is also necessary to ensure that
right-angle side is perpendicular to the measured surface.
To Next Page