EasyManua.ls Logo

Mee-go Otto - Page 2

Mee-go Otto
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Important Safety Information
IMPORTANT - KEEP THESE INSTRUCTIONS FOR FUTURE USE.
Please read this instruction manual carefully before use.
If you have any questions concerning the use of this child seat, please do not
hesitate to contact us.
WARNING: DO NOT PLACE A REAR
-
FACING CHILD SEAT IN THE FRONT SEAT
WHICH IS FITTED WITH AN AIRBAG. DEATH OR SERIOUS INJURY CAN OCCUR.
NOTICE
This is a “Semi-universal” ISOFIX CHILD RESTRAINT SYSTEM. It is approved to
Regulation No.44,04 series of amendments for general use in vehicles tted
with ISOFIX anchorages systems.
It will t vehicles with positions approved as ISOFIX positions (as detailed in
the vehicle handbook).
The mass group and the ISOFIX size class for which this car seat is intended is :
Group 0+ (0-13kg).
EXTREME HAZARD
Do not use in passenger seats equipped with airbags (SRS).
GENERAL
This child seat can be used for children less than 13kg in weight (Group 0+),
installed rearward-facing using ISOFIX anchorage.
Use the ISOFIX child restraint system exactly as shown in this instruction
manual.
Periodically inspect the harness for wear and tear, pay attention to the
attachment points, stitching and adjusting mechanisms.
In an emergency your child can be released quickly by pressing the red button
on the harness buckle.
In the event of an emergency it is important that the child can be released
quickly. NEVER LET YOUR CHILD PLAY WITH THE BUCKLE.
Do not modify this child restraint in any way.
Always ensure the harness is securely fastened.
CLEANING AND MAINTENANCE.
Regularly inspect the harness for wear, paying particular attention to
attachment points, stitching and adjusting devices.
Your child’s car seat must be replaced if it is involved in a collision.
Please keep this child seat in dry and ventilated place to avoid from damp.
The car seat can be cleaned with a wet sponge or cloth, using a mild detergent
and warm water and dry thoroughly.
Never use any solvent, chemical detergent or lubricant on any part of the
car seat.
The fabrics can be removed for cleaning. (See below).
REMOVING THE FABRICS.
1. Remove the blue plastic lap belts guides from either side of the car seat.
2. Remove the black metal panel underneath the seat which holds the crotch strap
in place.
3. Thread the crotch strap through the front of the seat and remove.
4. Open the press studs around the outer edges of the seat and remove fabrics.
!
30ć
P
Hand wash
below 30°C
Do not
bleach
Dry clean Do not
tumble dry
Do not iron

Related product manuals