Mee-go Otto - Page 6

6. Installing the car seat using the 3-point safety belt.
1. Push the car seat rmly against the backrest of the vehicle’s seat.
2. Route the lap belt through the lap belt guides on both sides of the child seat and
fasten it into the buckle until you hear a click.
3. Feed the diagonal section of the seat belt through the diagonal belt guide on the
rear of the child seat.
4. Ensure the seat belt is tight by pulling rmly upwards. Ensure the seat belt is not
twisted.
Caution: Ensure the vehicle’s seat belt is securely engaged, the seat belt is tight
and is not twisted before use.
For installation using the ISOFIX Base please see instruction manual in the
ISOFIX Base packaging.
7. Adjusting the handle.
To adjust the car seat handle press the red buttons on either side of the car seat
handle and adjust into the required position.
The handle has 3 positions:
1. When installed in a vehicle.
2. For carrying.
3. For removing baby from the seat.
CAUTION! Always ensure the seat handle is clicked into place and your child is
fastened in the seat correctly before lifting.
Should you nd a defect with this product:
Please keep your original receipt of purchase safe as it will be required should you
unfortunately nd a defect. The receipt must show the date of purchase clearly.
Should you nd a defect with this product you must rst contact the original place
of purchase. Repairs to any part of this product do not extend the warranty period.
Do not return your product direct to the manufacturer.
Warranty information:
For full warranty details please visit http://www.mee-go.co.uk/warranty/
To register your warranty:
Please visit http://www.mee-go.co.uk/register/
1.
3.
2.
Click!
4.
1. 2. 3.