7
Check the Remote-Board Pairing*
* Your board and remote have already been paired in the factory. You
need to do the following procedure when pairing a new remote to a
board.
• Turn on the board by pressing the power button on the board once.
• Turn on the remote by long pressing the “power” button on the
remote.
• Make sure the old remote is turned off, if you have one.
• Hold the power button on the board for 7 seconds.
• Press the “power” and “function” buttons on the remote at the
same time.
• The connection light on the remote will flash green light.
• When the power button blinks rapidly and the remote displays all
the specs, the board and remote have been paired.
To Next Page
Loading...