19
Universal Energy Meter MEg40
+
Defects of the instrument MEg40
+
and its accessories incurred during the guarantee
period shall be claimed by the user to the manufacturers of the instrument MEg40
+
.
Claims without the enclosed certicate of guarantee shall not be admitted.
e manufacturer shall not bear any responsibility for consequential damages caused
by the use of the instrument MEg40
+
and its accessories. No responsibility of the
manufacturer follows from this guarantee that would exceed the price of the instrument
MEg40
+
.
11/ ORDERING
e order should indicate a number of pieces of the universal instruments MEg40
+
with
one of the possible parameters:
• voltage range: 57.73 V, 230 V,
• current range: 1 A, 5 A,
• serial communication type: USB 2.0, RS485, RS232
You can order only one type of the serial communication.
Specify extra:
• requirement for memory CARD 16 MB
• requirement for extended SW,
• number of memory card readers,
• number and length of communication cables MEg40
+
-PC
• number of uninterruptible power supplies MEg102,
• number of USBhost / RS485 converters.
Note
In the order, you can dene the voltage level, rated primary voltages and currents or
wiring type in the place of installation of the instrument. e manufacturer will program
these data into the instruments before dispatching them. e given data can also be
programmed by the orderer during installation of the instrument. You can order also a
four-digit password dierent from the password dened by the manufacturer. (3355). e
password can be changed after installation of the instrument either by means of software
or from the keyboard. A changed or forgotten password can be read out only using the
user program MEg40
+
.
12/ MANUFACTURER
MEgA – Měřící Energetické Aparáty, a.s., 664 31 Česká 390, Czech Republic,
tel: +420 545 214 988 • mail: mega@e-mega.cz • web: http://www.e-mega.cz
To Next Page
Loading...