Need help?Do you have a question about the Megasat SAT>IP Server and is the answer not in the manual?
Configures the network interface for the SAT>IP switch/server.
Allows automatic or static IP configuration for the device.
Sets the time zone for the SAT>IP switch/server for upgrades.
Configure LNB type (Quad, Quattro, Uni-cable) and frequencies.
Select user bands and frequencies for Uni-cable setups.
Configure frequency and symbol rate for transponders.
Set polarization and satellite number for tuner settings.
Specify multicast address and required PIDs for streams.
Save or load device configuration settings.
Modify the user login password for the device.
Perform a software reboot of the SAT>IP server.
To Next Page
General