92
selection
11: Simple PLC stage running
completion indication
12: PLC cycle completion
indication
13: Reserved
14: Encoder direction output
15: Drive ready for running (RDY)
16: Drive fault
17: Host device switch signal
18: Reserved
19: Limiting torque
Torque command is
enabled when limited by the
torque limit value 1 or 2
20: Flux detection signal
Flux detection value is
enabled when exceeding P09.33
21: Zero servo completed
22: Analog torque offset enabled
23: Over-torque output
24: Under-torque output
25: Reserved
26: Reserved
27: Reserved
28: Reserved
29: Reserved
30: Reserved
31: Reserved
32: Reserved
33: Reserved
34: Drive FWD/REV indication
terminal
35: Motor 1 and 2 indication
terminal
36: Communication card ON/OFF
signal
37: Reserved
38: Reserved
39: Reserved
40: Reserved
41: Reserved
42: Reserved
43: PID feedback loss
44: PID feedback exceeding limit
Only the following function No. will
be shown in the shortcut menu: 0,
1, 3, 4, 5, 6, 7, 8, 9, 15, 16
To Next Page
Loading...