8
1.Make sure that the TV is ON.
2.Hold down the and
keys simultaneously until
the light indicator starts to
flash indicating that the
remote control is in
programming mode.
3. Press key four times
then point the remote
control at the appliance.
Press and release the
key slowly several times.
STOP when your TV goes
OFF.
4.When your TV is OFF, press
the and keys
simultaneously. When you
release the keys, three
flashes indicate that the
search operation has been
completed correctly.
5.
IF YOU DO NOT HAVE THE
PROGRAMME SELECTION
KEYS ON YOUR ORIGINAL
REMOTE CONTROL
If your remote control does
not have the programme
selection keys (e.g. / ,
+/-, CH+/-..etc) once you
have programmed Mycro,
you can still select the
programmes from 0 to 9, as
follows:
SET-UP
Read these instructions carefully before programming
your remote control!
To use the remote control with your TV, you must first
program Mycro as described below. You can also visit our
Internet site www.meliconi.com to have access to interactive
instructions for easier and faster
remote control programming.
PROGRAMMING YOUR REMOTE CONTROL
• Hold down the and
keys simultaneously until
the light indicator starts to
flash indicating that the
remote control is in
programming mode.
• Release the keys and
press 9 times within
12 seconds.
Three flashes indicate that
the operation has been
completed correctly.
• Make sure you can change
programmes from 0 to 9
using the and keys.
If not, repeat the search
operation, starting from
point 2.
Additional check
Check that all 7 keys are
operating correctly. If the
commands work incorrectly
or erratically, you have
probably entered a code for a
similar but different remote
control.
In this case, repeat the search
procedure from point 2 until
all keys respond correctly to
the commands sent.
Identify and take note of the TV code which you have
searched for, following the code noting procedure
(see "PROGRAMMED CODE NOTING" section).
To Next Page
Loading...
