Melitta Avanza F270-100 - Filling with Water; Adjusting Coffee Outlet Height; Using Milk for Beverages

Basic operation
40
GB
4.3 Filling with water
Only use fresh, cold water without carbon
dioxide for optimum coee enjoyment.
Change the water daily.
Information
The quality of the water largely deter-
mines the avour of the coee. Therefore,
use a water lter (see section6.3 Setting
the water hardness on page45 and sec-
tion7.6 Using a water lter on page52).
The Water display lights up and
requests you to rell water.
2
1
Fig. 8: Removing the water tank
1. Open the lid(2) of the water tank(1)
and pull the water tank upwards out of
the appliance by the handle.
2. Fill the water tank with water.
3. Insert the water tank into the appliance
from above and close the lid.
4.4 Adjusting the outlet for
coee beverages
The outlet (7) is height-adjustable. Set the
greatest possible distance between the
outlet and the vessel. Depending on the
vessel, push the outlet up or down.
7
Fig. 9: Adjusting the outlet for coee
beverages
4.5 Using milk
Use cooled milk for optimum coee
enjoyment.
27
25
Fig. 10: Commercial milk pack
1. Remove the milk hose(25) from the
holder.
2. Insert the milk hose into a conventional
milk pack(27) or into a vessel lled
with milk.